|
Home Improvement Articles |
Replacing a worn out or outdated bathroom
vanity is a quick and dramatic way to clean up a bathroom. With a
little planning and a step-by-step approach, you can complete this
alteration in a day. In fact, the biggest challenge may be just
deciding which vanity to buy.
Here are the steps you'll need to follow for installing your new
bathroom vanity, Shut off the water and disconnect the supply, use a
bucket to catch any water that drips from the supply lines and the
p-trap the white curved pipe in the center.
Loosen the caulk between the bathroom vanity and the wall with a
utility knife. You may have to go all the way down to the floor on
the sides to remove all the caulk. Remove the countertop very
carefully so as not to damage the wall, you may need a helper for
this step, especially if the countertop is large.
Loosen the screws attaching the bathroom vanity to the wall. A
cordless screwdriver makes it easier to do this step. Remove the
screws, being careful not to strip them. Remove the old vanity.
Locate the wall studs and make marks for new screw holes. Make the
marks for the studs a little higher than the top of the new vanity.
It's very important to make sure the bathroom vanity is flush
against the wall. You'll need to use shims and a carpenter's level
for this step. Once the vanity is positioned, attach it to the wall
with 2-1/2" wallboard screws.
Before you attach the new bathroom vanity top, install the new
faucet. It will make the job go faster in the long run, and it's one
less time that you'll have to get under the sink. Use tub-and-tile
caulk to secure the bathroom vanity top to the base.
Reconnect the plumbing this is also a good opportunity to replace
the p-trap. Teflon tape makes the connections easier and tighter.
Carefully apply a thin line of caulk around the countertop edges. Be
careful with this job, the caulk will be highly visible, so tidiness
really counts.
![]()
About the Author: D. Benjamin is the owner of
iapsales.com LLC - a family business specializing in HVAC products. We
are distributors of
Qmark Heaters,
electric tankless water heaters,
bathroom heaters,
patio heaters, electric heaters,
portable air
conditioners & electric towel warmers. Shop on line at
www.heateroutlet.com for these great home improvement products.
Iapsales.com LLC was established in 2003 and is the sister company to
Innovative Air Products located in historical Exeter, NH. We are a 2nd
generation manufacturers’ rep firm dedicated to providing residential &
commercial heating, ventilation and air-conditioning equipment. We offer
a great selection online at the lowest prices anywhere. We can also be
found on Facebook, Twitter and YouTube
| Blogroll | |||
|
| |||